Security Boss MaxSeal Dog Door
The MaxSeal Door Model pet door offers you the ultimate in pet door design. We use only the highest quality components to fabricate one of the industry’s best selling, high performance pet doors for walls. The MaxSeal is designed to provide the very best in an insulating seal and home security when locked off. There are 10 different sizes, allowing you to customize the size to any type of pet or situation. We also offer 10 different frame colors and two security panel colors to match or augment nearly any home decor.
Security Boss is setting the standard for pet doors in terms of pet door quality. Customers can customize their door with several options that make each pet door unique for their home. Whether it be the direction the security panel loads, the color options, high wind accessory magnets for very challenging environments or the option to get a door that will accommodate an aging pet with arthritis, Security Boss offers our customers the most flexibility and the best performing product in the shortest amount of time.
Just drag and drop your images into the gallery field, choose the fullwidth or split layout and set the images columns amount. That’s it!
GILTON RAGAV, Client
HOW TO INSTALL THE MAXSEAL DOG DOOR?
Most sliding screen doors are mounted on rollers. Tension screws are usually located near these rollers. They can be loosened to allow easy removal of your screen door.Some brands such as Pella doors have the screen doors attached to rollers suspended from the top of the screen door channel. There are screws along the interior top edge of the
screen door and once these are loosened, the door will drop enough to lift out of the floor.Position the pet door on your screen door, spline grooves up. The pet door must be mounted in the bottom corner. For example, most patio screen doors have the screen spline groove to the exterior; the Pet screen door spline groove should therefore be to the exterior as well.Mark the horizontal screen cut location on the sliding screen door frame with a
pencil. It is best to mark the cut location a 1/8″ in from the end of the H channel (Overlay flange) attached to the Pet screen door to allow enough screen material to roll into Pet Screen Door Spline groove. (Point A) Make the same mark at the bottom corner of the overlay flange – bottom corner of
your screen pet door; 1/8″ in from the end of the H channel. ( Point B) Cut (Do not pull screen away from spline) along the inside edge of your screen door to
remove this section. DO NOT REMOVE SPLINE.